Table of Contents
Advertisement
3.5 CONFIG MODE, CONTINUED
518750-2960
Rev. F
c).
To add a keystroke command to the listing, press the New Key soft
key.
i)
Enter the keystroke command number (1-999). Note: The
keystroke command numbers must correspond to the
commands programmed in the MXAT200 controller using the
SETMAX program.
ii) Enter a name for the command. Using the soft up and down
arrow keys or the jog control to scroll through the available
characters on the keyboard. You can also use the numeric
keypad to enter numbers.
iii) Press Enter.
iv) Perform step a) above to select the new command for the hard
key.
d.
To delete a keystroke command from the listing, highlight the key#
and name, then press the Del Key soft key. Note: if the key is
being used, an error message is displayed, "Unable to delete key
code. Key being used." Press OK to exit the error message. If the
key code has been selected or created during this programming
session, you must save a new selection for the hard key before you
can delete the key action. Exit the programming menus, then re-
enter the hard key programming screen and delete the key action.
e.
To change the name of a keystroke command, press the Edit Name
soft key, enter a new name, and press OK. The new name appears
in the listing.
f.
Press the OK soft key to save programming or press the Cancel soft
key to exit menu without saving. Note: Changes made with the
Edit Name, New Key, and Del Key soft keys do not revert back if
cancel is pressed.
2.
To program a Menu Action, press the Menu soft key.
A menu is displayed for programming the Menu Action
a.
If there are Menus listed, you can select from the listing by
highlighting the Menu Name. To view more of the listing, press the
soft up and down arrow keys or the soft Pg Up and Pg Dn keys.
When the menu is highlighted, press the Select Action soft key,
then the OK soft key.
37
HEMU001007
10/15/04
Advertisement
Table of Contents
