Honeywell HEGSA002 User Manual User Manual page 40

3.5 CONFIG MODE, CONTINUED
Press the YES soft key to save the settings or
press NO to exit the port settings menu. If you
press YES, the message DATA SAVED is
displayed.
Joystick Res=High – press this soft key to change the joystick (pan and tilt functions)
resolution to high or low. High = 26 increments, Low = 5 increments. The soft key
toggles between the options. After changing the joystick resolution, press the SAVE soft
key in the Hardware Config menu.
Var Buzzer Freq = ON – This soft key selection is available in firmware version 3.01 and
later. The default is ON to support the buzzer driver on circuit board 470502-1030, Rev.
A. If firmware version 3.01 or later is used with an earlier revision circuit board, the
buzzer driver for the older circuit may be selected by changing the Var Buzzer Freq to
OFF. Pressing this soft key toggles the buzzer frequency from variable (On) and fixed
(Off).
Zero Joystick – press this soft key to zero the joystick. This function electronically
centers the pan, tilt, and zoom positions of the joystick. This function should be
executed with the joystick in its neutral position. This function is executed automatically
on power-up.
KeyClick = HIGH – press this soft key to change the sound the ULTRAKey makes when
you press any soft key, programmed hard key, move the joystick or jog/shuttles . The
available options are low, high, or off. If you change the KeyClick setting, press the
SAVE soft key in the Hardware Config Menu. Note: The Key Click setting in SETMAX
must be enabled for the soft and hard key clicks to be operational, and the Joystick click
setting in SETMAX must be enabled for the joystick and jog/shuttle audible feedback to
be operational.
SAVE – Press this soft key to save all hardware configuration settings. The message,
"Save to Flash?" is displayed. Press YES to save the settings to flash memory; press
NO to exit without saving settings. If you pressed yes, the message, "Data Saved", is
displayed.
QUIT – Press this soft key to exit the hardware configuration settings.
518750-2960
Rev. F
CAUTION: Save any changes before exiting or settings
will be lost.
26 HEMU001007
10/15/04