Lan1/Lan2 Enable/Disable; Watch Dog; I 2 C Bus To Pci/Pci-Exp. Slots - Supero SUPERSERVER 6016T-T User Manual

LAN1/LAN2 Enable/Disable

Change the setting of jumper JPL1 to
enable or disable the LAN1 port and
JPL2 to enable or disable the LAN2
port on the serverboard. See the table
on the right for jumper settings. The
default setting is enabled.

Watch Dog

JWD enables the Watch Dog function,
a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will have
WD reboot the system if a program
freezes. Jumping pins 2-3 will gener-
ate a non-maskable interrupt for the
program that has frozen. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
2
I C Bus to PCI/PCI-Exp. Slots
2 2
Jumpers JI C1 and JI
connect the System Management Bus
2
(I C) to the PCI and PCI-E slots. The
default setting is Open (Disabled.) Both
jumpers must be set to the same setting.
See the table on the right for jumper
settings.
Chapter 5: Advanced Serverboard Setup
Note: when Watch Dog is enabled, the user
must write their own application software to
disable the Watch Dog Timer.
C2 allow you to
2
JI
JI 2
5-21
LAN1/2 Enable/Disable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
I 2 C to PCI/PCI-E Slots
Jumper Settings
Jumper Settings
2
C1: Closed JI C2:Closed
C1: Open JI 2 C2: Open
Defi nition
Enabled
Disabled