Lan1/Lan2 Enable/Disable; Sas Enable/Disable; Sas Raid Select; Watch Dog - Supero SUPERSERVER 6015C-M3 User Manual

LAN1/LAN2 Enable/Disable

Change the setting of jumper JPL1 to
enable or disable the LAN1 port and
JPL2 to enable or disable the LAN2
port on the serverboard. See the table
on the right for jumper settings. The
default setting is enabled.

SAS Enable/Disable

JPA1 allows you to enable or disable
the SAS controller. The default posi-
tion is on pins 1 and 2 to enable SAS.
See the table on the right for jumper
settings. This feature is only available
on the X7DCL-3.

SAS RAID Select

JPA2 allows you to select between SR
RAID, which is the default and enables
SAS RAID, or IT RAID, which treats
SAS drives as non-RAID drives and
requires a fi rmware fl ash. See the table
on the right for jumper settings. ontact
Supermicro tech support if using the IT
RAID setting. This jumper is available
on the X7DCL-3 only.

Watch Dog

JWD enables the Watch Dog function,
a system monitor that takes action
when a software application freezes
the system. Jumping pins 1-2 will have
WD reboot the system if a program
freezes. Jumping pins 2-3 will gener-
ate a non-maskable interrupt for the
program that has frozen. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
Chapter 5: Advanced Serverboard Setup
LAN1/2 Enable/Disable
Jumper Settings (JPL1/2)
Jumper Setting
Pins 1-2
Pins 2-3
SAS Enable/Disable
Jumper Settings (JPA1)
Jumper Settings
Pins 1-2
Pins 2-3
SAS RAID Select
Jumper Settings (JPA2)
Jumper Setting Defi nition
Open
Closed
Note: SR = Software RAID IT = Integrate
Target mode
Watch Dog
Jumper Settings (JWD)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: when Watch Dog is enabled, the user
must write their own application software to
disable the Watch Dog Timer.
5-19
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
IT RAID
SR RAID
Defi nition
Reset
NMI
Disabled