Table of Contents
Advertisement
S
S
UPER
ERVER 6016T-T User's Manual
Unpacking
The serverboard is shipped in antistatic packaging to avoid electrical static dis-
charge. When unpacking the board, make sure the person handling it is static
protected.
5-2
Serverboard Installation
This section explains the fi rst step of physically mounting the X8DTL-i into the
SC811TQ-520B chassis. Following the steps in the order given will eliminate
the most common problems encountered in such an installation. To remove the
serverboard, follow the procedure in reverse order.
Installing to the Chassis
1.
Remove the screws from the rear lip of the chassis cover (see Figure 2-5).
2.
Release the top cover by pushing it away from you until it stops. You can
then lift the top cover from the chassis to gain full access to the inside of the
server
3.
Make sure that the I/O ports on the serverboard align properly with their
respective holes in the I/O shield at the back of the chassis.
4.
Carefully mount the serverboard to the serverboard tray by aligning the board
holes with the raised metal standoffs that are visible in the chassis.
5.
Insert screws into all the mounting holes on your serverboard that line up with
the standoffs and tighten until snug (if you screw them in too tight, you might
strip the threads).
Note: Metal screws provide an electrical contact to the serverboard ground to
provide a continuous ground for the system.
Warning: To avoid damaging the serverboard and its components, do not apply
any force greater than 8 lbs. per square inch when installing a screw into a mount-
ing hole.
5-2
Advertisement
Table of Contents
