Table of Contents
Advertisement
CMOS Clear
Refer to the table on the right for
setting JBT1 to clear CMOS.
ways remove the AC power cord
from the system before clearing
CMOS.
Speaker Enable/Disable
JP32 allows you to enable or dis-
able the onboard speaker.
to the table on the right for jumper
settings.
LAN1/LAN2 Enable/Disable
Change the setting of jumper JP35
and JP31 to enable or disable LAN 1
and LAN 2, respectively. Refer to
the table on the right for jumper set-
tings.
Note: You must disable LAN1 to use an add-on
card in PCI 4.
Keyboard Wake-Up
The JPWAKE jumper is used to-
gether with the Keyboard Wake-Up
function in BIOS. Enable both the
jumper and the BIOS setting to al-
low the system to be woken up by
depressing a key on the keyboard.
Refer to the table on the right for
jumper settings.
Note: Your power supply must meet ATX specifi-
cation 2.01 or higher and supply 720 mA of standby
power to use this feature; however, you would need
1.5A for the SSR/SSE.
Chapter 5: Advanced Motherboard Setup
CMOS Clear Jumper Settings
Jumper
Position
Al-
1-2
2-3
O p e n
Refer
Closed
5-21
(JBT1)
Definition
Normal
C M O S C l e a r
Speaker Enable/Disable
(JP32)
Disabled
Enabled
L A N 1 /L A N 2
J u m p e r S e tting s
(J P 3 5 , J P 3 1 )
Jumper
Position
D efinition
O pen
Enabled
C losed
D isabled
K e yb o a rd W ak e -U p
J u m p e r S e tting s
(J P W A K E )
Jumper
Position
D efinition
1-2
D isabled
2-3
Enabled
Advertisement
Table of Contents
