Table of Contents
Advertisement
LAN1/LAN2 Enable/Disable
Change the setting of jumper JPL1 or
JPL2 to enable or disable the LAN1 and
LAN2 Ethernet ports, respectively. See
the table on the right for jumper set-
tings. The default setting is enabled.
PCI Slot SMB Enable
Use Jumpers I
2
C1/I
2
C2 to enable PCI
Slot SMB (System Management Bus)
support to improve system manage-
ment for the PCI slots. See the table
on the right for jumper settings.
USB Wake-Up
Use the JPUSB1 jumper to "wake-up"
your system by pressing a key on a
USB keyboard or clicking the USB
mouse. The JPUSB1 jumper is used
together with the USB Wake-Up feature
in the BIOS. Enable this jumper and the
USB feature in the BIOS to wake-up
your system via USB devices.
Note: When the USB function is set
to Enabled in the BIOS, and a USB
Wake-up jumper is set to Disabled,
remove the USB devices from the
USB ports whose USB jumper is Dis-
abled before the system goes into the
standby mode.
BMC Jumper
JPB is used to enable or disable the
BMC (Baseboard Management Con-
trol) Chip and the onboard IPMI con-
nection. This jumper is used together
with the IPMI settings in the BIOS. The
default position is on pins 1 and 2 to
Enable BMC. See the table on the right
for jumper settings.
Chapter 5: Advanced Motherboard Setup
LAN1/LAN2 Enable/Disable
Jumper Settings (JPL1/JPL2)
Jumper Setting
Pins 1-2
Pins 2-3
PCI Slot_SMB Enable
Jumper Settings
Jumper Setting
Short
Open (Default)
USB0/1 Port Wake-up
Enable/Disable (JPUSB1)
Pin#
Defi nition
1-2
Enabled (Default)
2-3
Disabled
BMC IPMI Enable/Disable Jumper
Settings
Defi nition
Pins 1-2
Enabled (Default)
Pins 2-3
Disabled
5-21
Defi nition
Enabled
Disabled
Defi nition
Enabled
Disabled
Settings
Advertisement
Table of Contents
