Serial Ata Power Cables; Dvd-Rom Drive Installation - Supero SUPERSERVER 6016T-T User Manual

S S
UPER ERVER 6016T-T User's Manual

Serial ATA Power Cables

SATA power cables should be routed so that they do not block the airfl ow through
the chassis. See the serverboard layout diagram for the location of the cable con-
nections.

DVD-ROM Drive Installation

The top cover of the chassis must be opened to gain full access to the DVD-ROM
drive bay. The DVD-ROM drive must have a "slim" profi le to fi t into the 6016T-T.
Installing a DVD-ROM Drive
1. Power down the system and remove the AC power cord.
2. Release the retention screws that secure the unit to the rack.
3. Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
4. Depress the two buttons on the top of the chassis to release the top cover
and at the same time, push the cover away from you until it stops. You can
then lift the top cover from the chassis to gain full access to the inside of the
server.
Note: Drives mount on rails and should "click" into place to be correctly and fully
installed in their bays. A red mark on a wire typically designates the location of
pin 1.
6-6