Henb-Gw Service Configuration Procedures - Cisco ASR 5x00 Home eNodeB Administration Manual

Chapter 3

HeNB-GW Service Configuration Procedures

This chapter is meant to be used in conjunction with the other chapters that describes the information needed to
configure the system to support HeNB-GW functionality for use in HeNB access networks.
It is recommended that you identify the options from the previous chapters that are required for your specific
deployment. You can then use the procedures in this chapter to configure those options.
This chapter describes following :

Information Required to Configure the System as an HeNB-GW

HeNB-GW Service Configuration

Logging Facility Configuration

Alarm and Alert Trap Configuration

SNMP MIB Traps for HeNB-GW Service

Event IDs for HeNB-GW Service
Important:
instructions for configuring the packet cards to be active can be found in the Configuring System Settings chapter of the
System Administration Guide.
Caution:
conflicting or blocked IP addresses and port numbers for binding or assigning. In association with some service steering
or access control features, like Access Control List configuration, use of inappropriate port number may result in
communication loss. Refer respective feature configuration document carefully before assigning any port number or IP
address for communication with internal or external network.
At least one packet card must be made active prior to service configuration. Information and
While configuring any base-service or enhanced feature, it is highly recommended to take care of
Cisco ASR 5x00 Home eNodeB Gateway Administration Guide ▄
31