Hnb-Gw Service Configuration Procedures - Cisco ASR 5000 Series Administration Manual

Chapter 3

HNB-GW Service Configuration Procedures

This chapter is meant to be used in conjunction with the other chapters that describes the information needed to
configure the system to support HNB-GW functionality for use in HNB access networks.
It is recommended that you identify the options from the previous chapters that are required for your specific
deployment. You can then use the procedures in this chapter to configure those options.
This chapter describes following:
Information Required to Configure the System as an HNB-GW
RTP Pool Configuration
HNB GW Service Configuration
Event IDs for HNB-GW Service
I
MPORTANT
Information and instructions for configuring PSCs/PSC2s to be active can be found in the Configuring System Settings
chapter of the System Administration Guide.
C
AUTION
conflicting or blocked IP addresses and port numbers for binding or assigning. In association with some service steering
or access control features, like Access Control List configuration, use of inappropriate port number may result in
communication loss. Refer respective feature configuration document carefully before assigning any port number or IP
address for communication with internal or external network.
OL-22991-01
:
At least one Packet Services Card (PSC/PSC2) must be made active prior to service configuration.
:
While configuring any base-service or enhanced feature, it is highly recommended to take care of
Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide ▄