Ggsn Service Configuration Procedures - Cisco ASR 5000 Series Administration Manual

Chapter 6

GGSN Service Configuration Procedures

This chapter is meant to be used in conjunction with the previous chapter that describes the information needed to
configure the system to support GGSN functionality for use in GPRS/UMTS networks.
It is recommended that you identify the options from the previous chapters that are required for your specific
deployment. You can then use the procedures in this chapter to configure those options.
Procedures are provided for the following tasks:
GGSN Service Configuration
GTPP Accounting Support Configuration
APN Configuration
DHCP Service Configuration
IP Address Pool Configuration on the System
FA Services Configuration
Common Gateway Access Support Configuration
Important:
prior to service configuration. Information and instructions for configuring PACs/PSCs to be active can be found in the
Configuring System Settings chapter of the System Administration Guide.
Caution:
conflicting or blocked IP addresses and port numbers for binding or assigning. In association with some service steering
or access control features, like Access Control List configuration, use of inappropriate port number may result in
communication loss. Refer respective feature configuration document carefully before assigning any port number or IP
address for communication with internal or external network.
OL-22944-02
At least one Packet Accelerator Card (PAC) or Packet Services Card (PSC) must be made active
While configuring any base-service or enhanced feature, it is highly recommended to take care of
Cisco ASR 5000 Series Gateway GPRS Support Node Administration Guide ▄