Hnb-Gw Service Configuration - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

▀ HNB-GW Service Configuration

HNB-GW Service Configuration
HNB-GW services are configured within source contexts and allow the system to function as an HNB-GW in the 3G
UMTS wireless data network.
Important:
that allows the system to process bearer contexts with IPsec authentication on SeGW. Commands that
configure additional HNB-GW service properties are provided in the different chapters of Command Line
Interface Reference.
These instructions assume that you have already configured the system level configuration as described in System
Administration Guide.
To configure the system to work as HNB-GW service with SeGW enabled:
Step 1
Optional. Configure threshold parameters by applying the example configuration in the Total HNB-GW Session
Thresholds chapter in Thresholding Configuration Guide.
Step 2 Optional. Configure system to enable logging facilities for HNB-GW service session subscriber and protocols by
applying the example configuration in the Logging Facility Configuration section.
Step 3
Optional. Configure congestion control parameters for HNB-GW service instance on system by applying the example
configuration in the Congestion Control Policy Configuration section.
Step 4
Optional. Enable and configure the SNMP Traps to generate alarms and alerts from system for various events and
thresholds for HNB-GW service instance by applying the example configuration in the Alarm and Alert Trap
Configuration section.
Step 5
Configure system to use source Boxer Internal address (SBIA) in hashing function for ECMP-LAG distribution of RTP
traffic over IuCS interface for by applying the example configuration in the Hashing Algorithm Configuration section.
Step 6
Create an interface in source context for Iuh interface by applying the example configuration in the Iuh Interface
Configuration section.
Step 7
Configure SS7 routing domain by applying the example configuration in the SS7 Routing Domain Configuration
section.
Step 8
Configure Peer Server identity for Circuit Switched (CS) core network in SS7 routing domain by applying the example
configuration in the Peer Server Id Configuration for CS Core Network section.
Step 9
Configure Peer Server identity for Packet Switched (PS) core network in SS7 routing domain by applying the example
configuration in the Peer Server Id Configuration for PS Core Network section.
Step 10
Configure SCCP network id with national variant by applying the example configuration in the SCCP Network Instance
Configuration section.
Step 11
Configure CS network parameters by applying the example configuration in the HNB-CS Network Configuration
section.
Step 12
Configure PS network parameters by applying the example configuration in the HNB-PS Network Configuration
section.
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
74
This section provides the minimum instruction set for configuring an HNB-GW service
HNB-GW Service Configuration Procedures
OL-25069-03