Apn Template Configuration To Support L2Tp; Modifying Apn Template To Support L2Tp - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

▀ APN Template Configuration to Support L2TP

APN Template Configuration to Support L2TP
This section provides instructions for adding L2TP support for APN templates configured on the system.
These instructions assume that the APN template was previously configured on this system.
Important:
for APN. For more information on commands that configure additional parameters and options, refer to the Command
Line Interface Reference. To configure the APN to support L2TP:
Step 1
Modify preconfigured APN template by following the steps in the
Step 2
Verify your APN configuration by following the steps in the
Step 3
Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode
command
save configuration
System Administration Guide and the Command Line Interface Reference.

Modifying APN Template to Support L2TP

Use the following example to modify APN template to support L2TP:
configure
context <ctxt_name>
apn <apn_name>
tunnel l2tp [ peer-address <lns_address> [ [ encrypted ] secret <l2tp_secret> ]
[ preference <num> ] [ tunnel-context <tunnel_ctxt_name> ] [ local-address
<agw_ip_address> ] [ crypto-map <map_name> { [ encrypted ] isakmp-secret <crypto_secret>
} ]
end
Notes:
 <
ctxt_name
 <
apn_name
 <
lns_address
 <
tunnel_ctxt_name
 <
agw_ip_address
 <
map_name
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
182
This section provides the minimum instruction set for configuring an APN template to support L2TP
. For additional information on how to verify and save configuration files, refer to the
> is the system context in which the APN template is configured.
> is name of the preconfigured APN template in which you want to configure L2TP support.
> is IP address of the LNS node to which this APN will communicate.
> is the L2TP context in which the L2TP tunnel is configured.
> is the local IP address of the GGSN in which this APN template is configured.
> is the preconfigured crypto map (ISAKMP or manual) which is to use for L2TP.
Modifying APN Template to Support L2TP
Verifying the APN Configuration for L2TP
IP Security
section
section.
OL-25069-03