Multiple Msc Selection Without Iu-Flex Configuration; Open Access Mode Configuration - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

▀ HNB-GW Service Configuration
configure
context <vpn_ctxt_name>
hnbgw-service <hnbgw_svc_name>
security-gateway bind address <segw_ip_address> crypto-template <crypto_template>
context <segw_ctxt_name>
end
Notes:
 <
vpn_ctxt_name
 <
segw_ctxt_name
where HNB-GW service is configured.
 <
hnbgw_svc_name
between HNB-GW and HNB.

Multiple MSC Selection without Iu-Flex Configuration

Use the following example to configure the multiple MSC selection over IuCS interface for MSC pooling and sharing.
configure
cs-network <cs_network_name>
associate sccp-network <sccp_network_id>
map lac range <lac_start> to <lac_end> point-code <msc_point_code>
end
Notes:
 <
cs_network_name
GW service.
 <
sccp_network_id
with HNB-CS Network <
 LAC value must be an integer between 0 and 65535.

Open Access Mode Configuration

Use the following example to configure the Open Access Mode for open HNBs in an HNB-GW service instance. It also
includes the paging optimization configuration for open HNBs.
configure
context <vpn_ctxt_name>
hnbgw-service <hnbgw_svc_name> -noconfirm
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
84
> is name of the source context in which HNB-GW service is configured.
> is name of the context in which Se-GW service is configured. By default it takes context
> is name of the HNB-GW service which is to be configured for used for Iuh reference
> is name of the HNB-CS network which is already configured and associated with HNB-
> is the identifier used for the SCCP network which is already configured and associated
cs_network_name
>.
HNB-GW Service Configuration Procedures
OL-25069-03