Table of Contents
Advertisement
IP Security
Verifying the DPD Configuration
These instructions are used to verify the dead peer detection configuration.
Step 1
Verify that your system is configured properly with crypto group with DPD by entering the following command in Exec
Mode in specific context:
sshow crypto group [ summary | name group_name ]
The output of this command is a concise listing of crypto group parameter settings configured on the system.
OL-25069-03
Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide ▄
Dead Peer Detection (DPD) Configuration ▀
181
Advertisement
Table of Contents
