Ipv4 Rtp Pool Creation Over Iuh - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

▀ RTP Pool Configuration
 <
cs_ip_pool_name
to be associated with CS Network Configuration to allocate RTP end point address towards CS network over
IuCS interface.
 IP pool size needs to be determined on the number of subscriber session on HNB-GW. It uses one IP address for
each session manager instance of user.
 To ensure proper operation with CS network configuration, RTP IP pools should be configured within a
destination context.
 Each address in the pool requires approximately 24 bytes of memory. Therefore, in order to conserve available
memory, the number of pools may need to be limited depending on the number of addresses to be configured
and the number of PSCs/PSC2s installed.
 Each PSC card requires a minimum of 10 RTP pools to be configured.
 Each PSC2 card requires a minimum of 16 RTP pools to be configured.
 Setting different priorities on individual pools can cause addresses in some pools to be used more frequently.
 For more information on commands/keywords that configure additional parameters and options, refer
command section in Context Configuration Mode Commands chapter of Command Line Interface Reference.

IPv4 RTP Pool Creation Over Iuh

Use the following example to create the IPv4 address RTP pool for RTP address allocation over Iuh interface
towards HNB.
configure
context <dest_ctxt_name>
ip pool <ip_pool_name> <ip_address/mask>
end
Notes:
 <
ip_pool_name
associated with HNB-GW service to allocate the RTP end point address in HNB-GW service over Iuh
interface.
 To ensure proper operation with HNB-GW configuration, RTP IP pools must be configured within the same
context as HNB-GW.
 IP pool size needs to be determined on the number of subscriber session on HNB-GW. It uses one IP address for
each session manager instance of user.
 Each address in the pool requires approximately 24 bytes of memory. Therefore, in order to conserve available
memory, the number of pools may need to be limited depending on the number of addresses to be configured
and the number of PSCs/PSC2s installed.
 Each PSC card requires 10 RTP pools to be configured.
 Each PSC2 card requires 16 RTP pools to be configured.
 Setting different priorities on individual pools can cause addresses in some pools to be used more frequently.
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
72
> is name of the IP pool configured in destination context named <
> is name of the IP pool configured in destination context named <
HNB-GW Service Configuration Procedures
dest_ctxt_name
ip pool
> and
dest_ctxt_name
OL-25069-03
> and