Modifying Pdsn Service To Support Compulsory L2Tp Tunneling; Verifying The Pdsn Service Configuration For L2Tp - Cisco ASR 5000 Series 3G Home NodeB Administration Manual

IP Security
 <
pdsn_svc_name
 <
lac_ctxt_name

Modifying PDSN service to Support Compulsory L2TP Tunneling

Use the following example to modify an existing PDSN service to support compulsory L2TP tunneling on your system:
configure
context <ctxt_name>
pdsn-service <pdsn_svc_name>
ppp tunnel-context <lac_ctxt_name>
ppp tunnel-type l2tp
end
Notes:
 <
ctxt_name
 <
pdsn_svc_name
 <
lac_ctxt_name

Verifying the PDSN Service Configuration for L2TP

These instructions are used to verify the PDSN service to support L2TP.
Step 1
Verify that your PDSN service is configured properly with L2TP by entering the following command in Exec Mode in
specific context:
show pdsn-service name service_name
The output of this command is a concise listing of PDSN service parameter settings configured on the system.
OL-25069-03
> is name of the PDSN service for which you are configuring attribute-based L2TP tunneling.
> is the name of the destination context where the LAC service is located.
> is the destination context where the PDSN service is configured.
> is name of the PDSN service for which you are configuring attribute-based L2TP tunneling.
> is name of the destination context where the LAC service is located.
Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide ▄
PDSN Service Configuration for L2TP Support ▀
175