Cisco ASR 5000 Series 3G Home NodeB Administration Manual page 70

▀ Information Required to Configure the System as an HNB-GW
Required Description
Information
Destination An identification string from 1 to 79 characters (alpha and/or numeric) by which the destination context will
context name be recognized by the system.
Interface name An identification string between 1 and 79 characters (alpha and/or numeric) by which the interface is
recognized by the system.
Multiple names are needed if multiple interfaces will be configured.
IP address and IPv4 addresses assigned to the interface.
subnet Multiple addresses and subnets are needed if multiple interfaces will be configured.
Physical port The physical port to which the interface will be bound. Ports are identified by the chassis slot number where
number the line card resides followed by the number of the physical connector on the card. For example, port 17/1
identifies connector number 1 on the card in slot 17. A single physical port can facilitate multiple interfaces.
Gateway IP Used when configuring static IP routes from the management interface(s) to a specific network.
address
GTP-U Tunnel Interface Configuration
GTP-U service An identification string from 1 to 63 characters (alpha and/or numeric) by which the GTP-U service can be
name associated with HNB-GW system in PS network instance for GTP-U tunnel towards core network. Various
control parameters can be configured for GTP-U packet transmission.
Multiple names are needed if multiple GTP services is used.
GTP-U Tunnel IPv4 addresses assigned to the interface as GTP-U bond address.
interface IP This address will be used for binding the GTP-U service (local bind address(es)) for sending/receiving GTP-
address U packets from/to PS core network using GTP-U tunnel.
Multiple addresses and subnets are needed if multiple interfaces will be configured.
GTP-U Tunnel The physical port to which the Iuh interface will be bound. The local GTP-U port used to communicate with
interface Port the PS core network over GTP-U tunnel interface.
RTP Pool Configuration
RTP IP Pool name An identification string from 1 to 63 characters (alpha and/or numeric) by which the RTP pool can be
identified on the system to allocate RTP IP address to session amanager instances over IuCS towards CS core
networks. It is to be associated with PS network configuration.
▄ Cisco ASR 5000 Series 3G Home NodeB Gateway Administration Guide
70
HNB-GW Service Configuration Procedures
OL-25069-03