red LED on the base will remain lit to indicate that Paging Mode is off. (This
light will go out when the button is pressed, then back on when it's
released.) Default = Paging Mode On.
* Paging Mode On
Pitch
Paging
When you press the Page button on the base, the scanner associated with
that base will begin beeping (see
the pitch of the paging beep for the scanner by scanning one of the follow-
ing bar codes. Default = Low.
* Low (1000 Hz)
High (4200 Hz)
Error Indicators
Scanner Address
Scan the following bar code to determine the address of the scanner you are
using.
Page Button
Scanner Address
Paging Mode Off
on page 3-3). You can set
Medium (3250 Hz)
3 - 9