Rs232 Timeout - Honeywell Voyager 1200g User Manual

Character-Based Flow Control with Timeout: The scanner asserts RTS
when it has a character to send and waits for a delay (see

RS232 Timeout

on page 2-22) for CTS to be asserted by the host. If the delay time expires
and CTS is not asserted, the device transmit buffer is cleared and scanning
may resume.
Default =RTS/CTS Off (Voyager 1200)
RTS/CTS Off, RTS Inactive (Voyager 1202).
* RTS/CTS Off
* RTS/CTS Off, RTS Inactive
Flow Control, No Timeout
Character-Based Flow Control,
No Timeout
Two-Direction Flow Control
Flow Control with Timeout
Character-Based Flow Control
with Timeout
RS232 Timeout
When using Flow Control with Timeout, you must program the length of the
delay you want to wait for CTS from the host. Set the length (in millisec-
onds) for a timeout by scanning the bar code below, then setting the time-
out (from 1-5100 milliseconds) by scanning digits from the Programming
Chart, then scanning Save. Default = 1000 ms (1 second).
RS232 Timeout
2 - 22