Inter-Scan Code Delay - Honeywell Voyager 1200g User Manual

Control + ASCII Mode On: The scanner sends key combinations for ASCII
control characters for values 00-1F (refer to the ASCII chart for Non-
Printable Characters, page A-4). Windows is the preferred mode. All key-
board country codes are supported. DOS mode is a legacy mode, and it
does not support all keyboard country codes. New users should use the
Windows mode.
Windows Mode Prefix/Suffix Off: The scanner sends key combinations
for ASCII control characters for values 00-1F (refer to the ASCII chart for
Non-Printable Characters, page A-4), but it does not transmit any prefix or
suffix information.
Default = Control + ASCII Mode Off.
Windows Mode Control + ASCII
Mode On
* Control + ASCII Mode Off
DOS Mode Control + ASCII Mode
On
Windows Mode Prefix/Suffix Off
Numeric Keypad Mode: Sends numeric characters as if entered from a
numeric keypad. Default = Off.
Numeric Keypad Mode On
* Numeric Keypad Mode Off

Inter-Scan Code Delay

When your keyboard detects that any key is being pressed, released, or
held down, the keyboard sends a packet of information known as a "scan
code" to your computer. This selection allows you to adjust the delay
2 - 17