Selecting The Rs-232/Rs-422 Port Protocol And Baud Rate (Rear Panel) - Extron electronics DXP DVI Pro Setup Manual

Selecting the RS-232/RS-422 Port Protocol and Baud
Rate (Rear Panel)
NOTE:
To view and configure the serial communications settings for the
switcher from the front panel:
1. Simultaneously press and hold all four Control buttons
(Enter, Preset, View, and Esc) until all of them light or blink
(approximately 2 seconds). In addition:
•
•
Press and hold the Enter, Preset,
View, and Esc buttons.
C O N T R O L
VIEW ESC
ENTER PRESET
Figure 18.
2.
Release the Control buttons.
The serial port settings are protected when front panel
lock mode 2 is selected. You can view the settings in lock
mode 2 but you cannot change them from the front
panel.
To enable changes to the mute settings, set the lock mode
to 0.
The Control button that represents the current baud rate
blinks.
The I/O button that represents the protocol blinks.
2 seconds
ENTER PRESET
All Control buttons light with
one flashing.
The Control button that continues flashing indicates the baud rate
as follows:
Enter — 9600
View — 38400
The I/O button that continues flashing indicates the protocol as
follows:
Video — RS-232
In this example, the port is set to RS-232 at 9600 baud.
RS-232/RS-422 and Baud Rate Display
DXP DVI Pro and DXP HDMI Series • Operation
C O N T R O L
VIEW ESC
Both I/O buttons light
with one flashing.
Preset — 19200
Esc — 115200
Audio — RS-422
I / O
VIDEO
AUDIO
19