Front Panel Config Port - Extron electronics DXP DVI Pro Setup Manual

g
Remote RS232/RS422 connector — Connect an RS-232 capable
host device such as a computer or a touch panel control to the
switcher via this 9-pin D connector for serial RS-232 or RS-422
control.
Figure 7.
In the "Remote Control" section, see
definitions of some of the SIS commands (serial commands to
control the switcher via this connector) and
Starting the Matrix Switchers Control
how to install and use the control software.

Front Panel Config Port

If desired, connect a control system or computer to the front panel
RS-232 Config port. Protocol for the port is:
9600 baud
•
8 data bits
•
• 1 stop bit
No parity
•
No flow control
•
RS-232
Configuration Port
Figure 8.
10 DXP DVI Pro and DXP HDMI Series • Setup
Pin RS-232 Function
1 —
1
2 Tx
6
3 Rx
4 —
9
5
5 Gnd
6 —
7 —
8 —
9 —
Remote RS232/RS422 Connector
ENTER
CONFIG
Front Panel Config Port
RS-422
Not used
Transmit data
Receive data
Not used
Signal ground
Not used
Not used
Not used
Not used
"SIS
Program" for details on
CONTROL I/O
ESC AUDIO
PRESET VIEW VIDEO
DXP SERIES
DIGITAL MATRIX SWITCHER
Function
— Not used
Tx– Transmit data (–)
Rx– Receive data (–)
— Not used
Gnd Signal ground
— Not used
Rx+ Receive data (+)
Tx+ Transmit data (+)
— Not used
Commands" for
"Installing and