Rear Panels And Connections - Extron electronics DXP DVI Pro Setup Manual

Rear Panels and Connections

Most of the connectors are on the rear panels of the DXP switchers.
The following figures show the rear panels of the four DVI models
and the four HDMI models.
NOTE:
1
1 2
5 6
LISTED
1T23
C U S
I.T.E.
Figure 3.
1
1 2
5 6
LISTED
1T23
C U S
I.T.E.
Figure 4.
WARNING:
CAUTION:
a
AC power connector — Plug a standard IEC power cord into this
connector to connect the switcher to a 100 VAC to 240 VAC, 50 or
60 Hz power source.
6 DXP DVI Pro and DXP HDMI Series • Setup
The illustrations below show DXP 88 DVI Pro and
DXP 88 HDMI models, with 8 input and 8 output connectors.
The rear panels of the other DXP models are identical to
these models except for the number of inputs and outputs
(see "About the DXP DVI Pro and DXP HDMI Series Matrix
Switchers" in the "Introduction" section for the available
matrix sizes).
2
DVI PRO - HDCP COMPLIANT
DVI-D INPUTS
3 4
7 8
DXP DVI Pro Rear Panel
2
HDMI - HDCP COMPLIANT
HDMI INPUTS
3 4
7 8
DXP HDMI Rear Panel
Remove power from the system before making any
connections.
Use electrostatic discharge precautions (be
electrically grounded) when making connections.
Electrostatic discharge (ESD) can damage equipment,
although you may not feel, see, or hear it.
3
DVI-D OUTPUTS
1 2 3
5 6 7
3
HDMI OUTPUTS
1 2 3
5 6 7
4
5
LAN
6
4
7
8
4
5
LAN
6
4
7
8