Advanced features consist of:
•
Setting video and audio output mutes
•
Creating I/O groups
•
Setting the RS-232/RS-422 port protocol and baud rate
•
NOTE:
The switcher is shipped from the factory in lock
mode 2.
Selecting lock mode 2 or toggling between lock modes 2
and 0
NOTES:
•
If the switcher is in lock mode 0 or 1, this procedure
selects mode 2.
•
If the switcher is in lock mode 2, this procedure selects
mode 0 (unlocks the switcher).
Toggle the lock on and off by pressing and holding the Enter, Video,
and Audio buttons simultaneously until the following buttons blink
twice (approximately 2 seconds).
The Esc, Video, and Audio buttons blink if the DXP is now in lock
•
mode 2.
The Video and Audio buttons blink if the DXP is now in lock
•
mode 0.
Press and hold simultaneously.
I / O
VIDEO
AUDIO
ENTER
2 seconds
I / O
VIDEO
ENTER
AUDIO
Figure 16.
Press and Hold the Enter and the Two I/O Buttons
Simultaneously
Selecting lock mode 2 or toggling between modes 2
and 1
NOTES:
•
If the switcher is in lock mode 1, this procedure selects
mode 2.
•
If the switcher is in lock mode 2, this procedure selects
mode 1 (locks all switcher functions except selecting
mode 2).
The buttons blink twice.
Release the buttons.
DXP DVI Pro and DXP HDMI Series • Operation
17