Extron electronics DXP DVI Pro Setup Manual page 14

c
Output connectors —
NOTE:
•
•
d
Ethernet port — If desired, connect the DXP switcher to a
computer, a network WAN or LAN hub, or a control system via
this RJ-45 connector. With the Ethernet connection, you can use a
computer to control the networked switcher with SIS commands,
the Matrix Switchers Control Program, or the embedded HTML
pages on the switcher.
Ethernet connection indicators — The Link and Act LEDs
indicate the status of the Ethernet connection.
•
•
Ethernet links use Category (CAT) 3, 5e, or 6 unshielded twisted
pair (UTP) or shielded twisted pair (STP) cables, terminated with
RJ-45 connectors. Ethernet cables are limited to 328 feet (100 m).
NOTES:
Pins:
1 2 3 4 5 6 7 8
Pin Wire Color
1 White-green
2 Green
3 White-orange
4 Blue
5 White-blue
6 Orange
7 White-brown
Insert Twisted
8 Brown
Pair Wires
RJ-45
Connector
A cable that is wired as T568A at one end
and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable.
Figure 6.
8 DXP DVI Pro and DXP HDMI Series • Setup
The switchers do not alter the video signal in any way.
The signal that is output by the switcher is in the same
format as the input signal.
DVI Pro series: Connect DVI output devices to these female
29-pin DVI-I output connectors.
HDMI series: Connect HDMI output devices to these female
19-pin type A HDMI output connectors.
Link: Indicates that the switcher is properly connected to an
Ethernet LAN. This green LED should light steadily.
Act (Activity): Indicates transmission of data on the RJ-45
connector. This yellow LED should flicker as the switcher
communicates.
• Do not use standard telephone cables. Telephone
cables do not support Ethernet or Fast Ethernet.
• Do not stretch or bend the cables because this can
cause transmission errors.
Crossover Cable
End 1 End 2
Wire Color
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
T568A T568B
RJ-45 Connector and Pinout Tables
Straight-through Cable
End 1
Pin Wire Color Wire Color
1 White-orange White-orange
2 Orange Orange
3
White-green White-green
4 Blue Blue
5 White-blue White-blue
6 Green Green
7 White-brown White-brown
8 Brown Brown
T568B
A cable that is wired the same at both ends
is called a "straight-through" cable, because
no pin or pair assignments are swapped.
End 2
T568B