Error Responses; Symbol Definitions - Extron electronics FOX T UWP 302 User Manual

Error responses

When the FOX T UWP 302 receives an SIS command and determines it is valid, it performs
the command and sends the corresponding response to the host device. If the command is
determined invalid or contains invalid parameters, the transmitter returns an error response
to the host. The error response codes are:
= Invalid input number
E01
= Invalid switch attempt in this mode
E06
= Invalid command
E10
= Invalid port number
E12
Using the command and response table for SIS commands
The Command and Response Tables
acceptable in the command field except where indicated. Figure 10 shows the hexadecimal
equivalent of ASCII characters used in the command and response tables.
ASCII to Hex Conversion Table
Space
Figure 10. ASCII to Hexadecimal Conversion

Symbol definitions

= Carriage return and line feed
]
¦ = Carriage return with no line feed
}
or
= Space
•
= Escape key
E
or W
FOX T UWP 302 Wallplate Transmitter • SIS Configuration and Control
= Invalid parameter
E13
= Not valid for this configuration
E14
= Invalid command for signal type
E17
= Busy
E22
begin on page 16. Lowercase letters are
•
14