Table of Contents
Advertisement
Rear Panel Features
Figure 2.
a
b
c
Right Side
FOX T UWP 302 Rear Connectors from the Side and Rear Panels
Fiber connector — For one-way video, audio, and serial
communication from the transmitter to a receiver, connect a fiber optic
cable between the Tx port on the transmitter and the Rx port on a
receiver.
To return serial data from a receiver to the transmitter (such as
responses from a controlled device) or for HDCP-compliance, connect a
fiber optic cable between the Rx port on the transmitter and the Tx port
on the receiver (see
Wiring for Fiber Communication
NOTES:
•
Ensure the proper fiber optic cable is used. Typically,
singlemode fiber optic cable has a yellow jacket and multimode
fiber optic cable has an orange or aqua jacket.
•
Only one fiber optic cable, transmitter-Tx-to-receiver-Rx,
is required for video, audio, and serial command transmission,
but the HDMI signal output on the receiver will not be
HDCP-compliant.
Remote RS-232 port — For serial RS-232 control, connect a host device
to the transmitter via the leftmost poles (Tx, Rx, and G) of this 5-pole
captive screw connector (see
Communication
on page 10 for wiring configuration).
Alarm output port — For remote monitoring of the status of fiber optic
link 2, connect a custom or furnished monitoring device to the transmitter
via the rightmost poles (1 and 2) of this 5-pole captive screw connector (see
Wiring for Remote RS-232 and Alarm Communication
NOTE: Pins 1 and 2 short when link 2 does not detect any connection.
Power connector — Connect the provided external 12 VDC power supply
to this 3.5 mm, 2-pole captive screw connector (see
Supply
on page 11).
FOX T UWP 302 Wallplate Transmitter • Installation and Operation
a
b
c
Rear
Wiring for Remote RS-232 and Alarm
Wiring the Power
Tx
Rx
Tx
REMOTE
Rx
RS-232
G
1
ALARM
2
+
POWER
12V
-
0.6A MAX
Tx
OPTICAL
on page 9).
Transmitter
to
Receiver
Tx
OPTICAL
Tx Rx G
Tx Rx
G
on page 10).
Rx
Rx
1
2
1
2
5
Advertisement
Table of Contents
