Magazines; Inserting Tape Cartridges Into A Magazine; Figure 3.5 Slot Numbering Left Magazine With Mailslot; Table 3.2 Slot Numbering, Left Magazine - Fujitsu ETERNUS LT40 S2 Installing, Starting Up And Maintaining

Chapter 3 Operating the Tape Library

3.4 Magazines

A cleaning cartridge will not be used once it has exceeded its maximum count of operations (50 loads) or
when a medium error was detected during operation.
If there is more than one cleaning cartridge available, the one with highest load count will be used. This
causes the cleaning cartridge with the highest load count to wear out first.
3.4 Magazines
Cartridges are stored in magazines. Up to 12 cartridges can be stored in each magazine. Magazines may be
removed and inserted individually.
The ETERNUS LT40 S2/LT60 S2 LTO Library tape library has two removable magazines in the 4U library (see
Figure 3.5 and
is stopped when a magazine is removed. See section
62). The magazines can be released using the Operator Control Panel (OCP) or the Remote Management Unit
(RMU). In case the OCP or RMU initiated process has failed or the library no longer has power a manual
emergency release is available. See section
3.4.1

Inserting Tape Cartridges Into a Magazine

The slot numbering scheme is shown in
magazine.

Figure 3.5 Slot numbering left magazine with mailslot

Table 3.2 Slot numbering, left magazine
No.
1*,5*,9*
2 -12
FUJITSU Storage ETERNUS LT40 S2/LT60 S2 LTO Library Installing, Starting Up and Maintaining
Figure 3.7). Magazine access can be password protected. For safety reasons, the robotic motion
11
1 0
6
9 *
2
5 *
1 *
Description
Mailslot
Slot
Copyright 2018 FUJITSU LIMITED
"3.5.6.6 Changing the Administrative Password" (page
"4.4 Magazine Does not Unlock via OCP or RMU" (page
Figure 3.5 for the left magazine, and
1 2
8
4
7
3
48
77).
Figure 3.7 for the right
P3AM-5392-07ENZ0