Applying Power; Figure 19. The Back Panel Of The Switch - Olicom CrossFire 8600 Manual To Operations

64

Applying Power

The switch chassis does not have an on/off switch. Power is on when the unit is
plugged into a power source .
There are no user serviceable parts inside a switch. Any internal upgrades or service
should be performed by Qualified Personnel only .
Warning: Unplug the power cord before you work on a system that does not have
an on/off switch.
Warning: When installing the unit, the ground connection must always be made
first and disconnected last.
Warning: This equipment is intended to be grounded. Ensure that the host is
connected to earth ground during normal use.
Warning: Do not touch the power supply when the power cord is connected. Line
voltages are present within the power supply when the power cord is connected.
Use the following steps to power on your equipment.
1. Ensure that you are using the correct power source.
2. Using a power cable that complies with national regulations, plug the female
end of the cable into the AC power connector on the back panel of the switch
(see Figure 19).
3. Plug the male end of the power cord(s) into a properly grounded electrical
outlet.

Figure 19. The Back Panel of the Switch

CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641 Installation