Creating A Console Session Using A Modem; Stopping The Console Session; Table 21. Modem Settings - Olicom CrossFire 8600 Manual To Operations

132

Creating a Console Session Using a Modem

Use the Serial Link Configuration menu to configure the switch in order to
communicate with a console via a modem.
Set your modem according to the table below.
Setting
Echo
Result codes
Wait for connection
Pause between calls
Drop DTR between calls
Send CR between calls
Auto baud detect
Send init if CD high
Maximum dial attempts

Table 21. Modem Settings

Caution: Some modems use slightly different names for the options. It is important
that your modem be configured correctly. The settings shown in italics are
particularly important. If your modem is not configured correctly, the connection
may cause the switch to reset.
Start the console by pressing
the console to terminate the Telnet session and press
console session.

Stopping the Console Session

Pressing
CTRL-P
returns to the greeting menu.
B
CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641
Off
Off
45 seconds
6 seconds
Yes
Yes
On
Yes
999
ENTER
returns the console session to the main menu, and pressing
Value
. If a Telnet session is active, press
ENTER
at
ENTER
again to start the
CTRL-
Switch Configuration