Unpacking Instructions; Materials Needed For Installation - Olicom CrossFire 8600 Manual To Operations

Unpacking Instructions

There are no special safety precautions that need to be taken when unpacking the
switch. Simply follow these steps:
1. Open the large carton.
2. Remove the switch from its protective packaging.
3. Visually inspect the switch to ensure that it was not damaged during shipment.
4. Check the contents of the carton. Along with this manual, the carton should
contain:
•
One CrossFire 8600 Token-Ring Switch
OR
CrossFire 8605 Token-Ring Fiber Switch
•
One CrossFire 8600/8605 Token-Ring Switches Guide to Operations
(this guide)
•
One OC-8830 Token-Ring Switch Program Disk Set
•
One OC-8840 Token-Ring Switch Manager for HP OpenView for Windows
•
One CrossFire 8600 Series Token-Ring Switch Manager for HP OpenView for
Windows Guide to Operations (Olicom document number DOC-6960)
•
One plastic bag containing four adhesive rubber feet and rack mounting
screws, Allen key, nuts and washers.
If any item is missing or damaged, contact your place of purchase.

Materials Needed for Installation

To install the switch, you need the following items:
•
If the unit will be installed in a rack, you need:
— A rack inventory chart and a cabling chart from your network
administrator.
— The supplied set of screws, nuts and washers along with the Allen key tool.
— A properly earthed power cord.
•
If the unit will be installed on a surface (such as a tabletop), you will need:
— A cabling chart from your network administrator.
— The four supplied adhesive rubber feet.
— A properly earthed power cord.
CrossFire 8600/8605 Token-Ring Switches v. 1.2, P/N: 710001641
57
Installation