2.5
LED Status Indicators
The LED status indicators are located on the rear of the projector.
LAMP 1 LED
y
Red (short blink)
Yellow (no blink)
Green (no blink)
Green (short blink)
Off
LAMP 2 LED
y
Red (short blink)
Yellow (no blink)
Green (no blink)
Green (short blink)
Off
E Series User Manual
020-000515-01 Rev. 2 (03-2013)
LED Status
Failed to strike lamp after 5 attempts (strike attempts will
stop).
Lamp has unexpectedly shut down (system goes into
cool down state).
Lamp time has expired and lamp should be replaced.
(projector also begins to display the replace lamp On
Screen Display message at startup).
Lamp 1 turn ON ok
Projector is switching to Lamp 1 (Lamp 2 is off)
(selected by OSD menu "Current Lamp": 1/ 2/ Both )
Lamp is off
LED Status
Failed to strike lamp after 5 attempts (strike attempts will
stop).
Lamp has unexpectedly shut down (system goes into
cool down state).
Lamp time has expired and lamp should be replaced.
(projector also begins to display the replace lamp OSD
message at startup).
Lamp 2 turn ON ok
Projector is switching to Lamp 2 (Lamp 1 is off)
(selected by OSD menu "Current Lamp": 1/ 2/ Both )
Lamp is off
Section 2: Introduction
Projector State
Projector State
2-7