LevelOne WAB-3003 User Manual page 61

 Rule ID: The numbering of this specific rule will decide its priority among available firewall
rules in the table.
 Rule name: The rule name can be specified here.
 Ether Type: The drop-down list will provide the available types of traffics (ALL, IPv4,
IEEE802.3, 802.1Q, ARP, and RARP) subject to this rule.
 Interface: It can indicate inbound/outbound direction with desired interfaces (VAP1~VAP8)
 Service (when Ether Type is IPv4): Select the available upper layer protocols/services
from the drop-down list.
 DSAP/SSAP (when Ether Type is IEEE802.3): The value can be further specified for the
fields in 802.2 LLC frame header.
 Type (when Ether Type is IEEE802.3): The field can be used to indicate the type of
encapsulated traffics.
 Vlan ID (when Ether Type is 802.1Q): The Vlan ID is provided to associate with certain
VLAN-tagging traffics.
 Priority (when Ether Type is 802.1Q): It denotes the priority level with associated VLAN
traffics.
 Encapsulated Type (when EtherType is 802.1Q): It can be used to indicate the type of
encapsulated traffics.
 Opcode (when EtherType is ARP/RARP): This list can be used to specify the ARP Opcode
in ARP header.
 Source: MAC Address/Mask indicates the source MAC; IP Address/Mask indicates the source
IP address (when EtherType is IPv4); ARP IP/MAC & MASK indicate the ARP payload fields.
 Destination: MAC Address/Mask indicates the destination MAC; IP Address/Mask indicates
the destination IP address (when EtherType is IPv4); ARP IP/MAC & MASK indicate the ARP
payload fields.
 Action: The rule can be chosen to be "Block" or "Pass".
 Remark: The note of this rule can be specified here.
When the configuration for firewall rules is provided, please click "SAVE" and reboot system to
let the firewall rules take effect.
WAB-3003 108M 11g
56
User's Manual
Outdoor PoE CPE/ AP/ Bridge