LevelOne WAB-3003 User Manual page 36

 VLAN for Management: The Ethernet traffic from the system can be tagged with VLAN tag with
specific ID.
 SNMP Configuration: By enabling SNMP service, the remote SNMP manager could obtain the
system status.
 Enable/ Disable: Select Enable to activate this function or Disable to inactivate it.
 Community String: The community string is required when accessing the Management
Information Base (MIB) of the system.
Read: Enter the community string to access the MIB with Read privilege.
o
Write: Enter the community string to access the MIB with Write privilege.
o
 Trap: When enabled, events on Cold Start, Interface UP & Down, and Association &
Disassociation can be reported to an assigned server.
Enable/ Disable: Select Enable to activate this function or Disable to inactivate it.
o
Server IP Address: Enter the IP address of the assigned server for receiving the trap
o
report.
 Syslog Configuration: By enabling this function, specify a remote syslog server which could
accept system log messages from the system remotely. Therefore, by reading the syslog
message in the remote server, review activities of all installed the system in the network.
 Enable/ Disable: Select Enable to activate this function or Disable to inactivate it.
 Server IP: The IP address of the Syslog server for receiving the reported events.
 Server Port: The port number of the Syslog server.
 Log Level: Select the desired level of received events from the drop-down list box.
 Auto Reboot: The option can be enabled to reboot system automatically with preferred Reboot
Time from drop-down list.
 Enable/ Disable: Select Enable to activate this function or Disable to deactivate it.
 Reboot Time: Select an appropriate time from the drop-down list box. Since all users on the
network will be disconnected during reboot, it is suggested to set the reboot time during an
off-peak period to reduce impacts on online users.
WAB-3003 108M 11g
31
User's Manual
Outdoor PoE CPE/ AP/ Bridge