LevelOne WAB-3003 User Manual page 49

 WDS: The device supports up to 8 WDS peers. After providing WDS peer's MAC address, click on
Add to add this link to the table shown on User Interface.
Enable: Select Enable to activate the specified WDS link.

MAC Address: Enter the MAC address of the WDS peer. Click Add to add it into the list.

Security Type: Select an appropriate security type for the WDS link, either None, WEP or

TKIP/AES; the type selected needs to be the same as the one configured at the WDS peer.
Site Distance: Fill in the distance from the farthest WDS peer to derive the suggested

values for Slot Time, ACK Timeout, and CTS Timeout.
Slot Time: With the concern of common medium access, Slot Time will allow the station to

learn possible access from other station at the beginning of previous slot. This value
should be equal or less than half of ACK/CTS Timeout.
ACK Timeout: A valid 802.11 data transmission will be acknowledged with suck

"ACK" from the receiving radio or the retransmission will start if such ACK is not received
within Timeout period. This value should be set equal or larger than RTT to the farthest
WDS peer.
CTS Timeout: This CTS acknowledges the previous sent RTS request in 802.11 common

medium access. Its Timeout value can be treated the same as that for ACK Timeout
and should be set equal or larger than RTT to the farthest WDS peer.
WAB-3003 108M 11g
44
User's Manual
Outdoor PoE CPE/ AP/ Bridge