Removal - NEC Express5800/R120b-2 User Manual

3-14 Setting Up Your Server

Removal

Remove the server from the rack in the following procedure.
1.
Make sure that the server is off-powered, and disconnect the power cords and all the
interface cables from the server.
2.
Unlock the front bezel with the security key.
<2>
3.
<This step is required only when the optional cable arm is mounted.>
Remove the cable arm from the server.
Observe the following instructions to use the server safely. Failure to follow
these instructions may cause a fire, personal injury, or property damage.
See pages 1-4 to 1-11 for details.
Do not install/remove the server in/from the rack only by a single person.
Do not pinch your finger with mechanical components.
Do not apply any load on the server being pulled out from the rack.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
Do not pull out the server from the rack while it is operating.
Security key slot
CAUTION
<1>