NEC Express5800/R120b-2 User Manual page 183

5-56 Installing the Operating System with Express Setup
Create Team
1.
Open the [Device Manager].
2. Open [Network adapters] → [Intel(R) xxx] properties.
3.
Click [Teaming] tab and check the [Team this adapter with other adapters] check box.
Click [New Team].
4.
Fill the name of the team in [Specify a name for the team] and click [Next].
5.
Include the adapter to the team and click [Next].
6.
Select a team mode, and then click [Next].
IMPORTANT: Following team types are supported.
Adapter Fault Tolerance
Adaptive Load Balancing
Static Link Aggregation
Switch Fault Tolerance
7.
Click [Finish].
Click [TEAM: "Team name"] from [Device manager] → [Network adapters] to modify
8.
the team.
Click [Settings] tab and click [Modify Team] button.
9.
Refer to the following procedure to set the team member adapter priority status.
– Set Primary
Point the adapter and click [Set Primary] button.
– Set Secondary
Point the adapter and click [Set Secondary] button.
NOTE: Adapter priority config can be confirmed by the following
procedure:
1. Click [TEAM: "Team name"] from [Device manager] → [Network
adapters].
2. Click [Settings] and confirm Adapters in team list.
10. Click [Test Switch] → [Run test] to confirm the adapter team is properly setup.
Confirm the result in [Test results]
11.
Restart the system.