Removal; Installing Raid Controller - NEC Express5800/R120b-2 User Manual

12.
After inserting the riser card, firmly press on it with your fingers to connect it.
13.
Install the components you removed previously.
14.
Verify that POST displays no error messages.
If POST displays an error message, take a note on the message and see the POST error
messages listed on page 4-15.
15. Run the BIOS SETUP utility and select "Yes" for [Advanced] → [Reset Configuration
Data].
This setting is required to update the hardware configuration information. See page 4-8 for
details.

Removal

Remove a PCI card in reverse order of the installation steps. After removal, use the [Boot] menu of
the BIOS setup utility to set the boot order (as described on page 4-33).

Installing RAID Controller

Take the following steps to install the optional RAID controller in the RAID Controller slot.
If using an optional RAID controller (N8103-129/130)
For a detailed description, see the instruction manual that came with your optional RAID controller
(N8103-129/130).
IMPORTANT:
component that is extremely sensitive to static electricity. Before
handling the controller, touch the metal frame of the server or ground
yourself in some other way to discharge static electricity from your
body. In addition, do not touch the terminals of the RAID controller
card with your bare hands or place the card on a desk without anything
to protect it. Details about static electricity are provided on page 9-3.
NOTE:
The optional RAID controller is an electronic
When inserting an optional RAID controller, on the
Upgrading Your Server 9-59