Removing The Heat Roller - Kyocera FS-1800 Service Manual

(3) Removing the heat roller

WARNING
The heat roller is extremely hot immediately after the printer was running. Allow
a substantial period of time until it cools down.
1. Remove and split the fuser unit. See page 5-29.
2. Remove the heater lamp. See the previous page.
3. Remove the separators. See page 5-32.
4. Pull up both heat R bush 1 and heat L bush 2 at the same time.
5. Remove heat gear Z36
FS-1800/1800N | FS-3800/3800N
3, heat R bush 1, and heat L bush 2 from the heat roller 4.
*1 *2
/Z26
3
1
Figure 5-2-31 Removing the heat roller
*1
: FS-1800/1800N
4
5-34
*2
: FS-3800/3800N
2