Detailed Fault Codes; Fault Descriptions - Fisher & Paykel SMARTDRIVE Service Manual

7

DETAILED FAULT CODES

INTRODUCTION
The format for fault description in this booklet follows the Primary, Secondary, Tertiary and
Quaternary fault source system. These sources have mostly been arranged in order of most likely
source of fault, but in some cases the sequence has been modified to aid the servicing procedure.
It should be noted that the fault source Pump System includes the pump and drain hose
assembly.
These fault codes are specific to this series of machines.
Fault code shows the last recorded fault. Always confirm fault.
7.1

Fault Descriptions

1. (00000001) Motor Control Module Fault
The Motor Control Module has encountered an error when writing to an EEPROM address.
Primary Source:
Action:
3. (00000011) Motor Control Module Fault
The Motor Control Module has found a memory error.
Primary Source:
Action:
9. (00001000) Size Switch Error
The Display size setting is not set.
Action,:
10. (00001010) Temperature Sensor (Thermistor) Error
The temperature sensor may be open circuit or the ambient temperature is below 14
10 o C.
Primary Source:
Secondary Source: Motor Control Module
DETAILED FAULT CODES
Motor Control Module.
Replace Motor Control Module.
Motor Control Module.
Replace Motor Control Module.
Reselect the size of the machine by using the SIZE SETTING MODE.
To set the size, turn the power on at the power point and off at the
console. Press and hold Wash Temperature Up button then press
Power button until the machine gives 4 short beeps and the pattern
of LEDs change.
 Press Spin Speed Up button, the Spin Hold LED should be on for
the 7.5 / 8.0kg (25.5in / 650mm wide).
 Press Power to confirm the setting and also exit this mode.
Thermistor
43
421827
o
F / -