Detailed Fault Codes; Fault Descriptions - Fisher & Paykel Ecosmart GWL15-US-96200 Service Manual

517792A
8

DETAILED FAULT CODES

INTRODUCTION
The format for fault description in this booklet follows the Primary, Secondary, Tertiary and
Quaternary fault source system. These sources have mostly been arranged in order of most likely
source of fault, but in some cases the sequence has been modified to aid the servicing procedure.
It should be noted that the fault source Pump System includes the pump and drain hose
assembly.
These fault codes are specific to the Phase 7 machines.
Fault code shows the last recorded fault. Always confirm fault.
8.1

FAULT DESCRIPTIONS

1. (00000001) Motor Control Module Fault
The Motor Control Module has encountered an error when writing to an EEPROM address.
Primary Source:
Action:
3. (00000011) Motor Control Module Fault
The Motor Control Module has found a memory error.
Primary Source:
Action:
9. (00001000) Size Switch Error
The Display size switch setting does not match that which is stored in memory.
Action, GW Machines: Reselect the size of the machine by using the SIZE SETTING
PHASE 7 EcoSmartä & Intuitive Ecoä
DETAILED FAULT CODES
Motor Control Module.
Replace Motor Control Module.
Motor Control Module.
Replace Motor Control Module.
MODE.
To set the size switch, turn the power on at the power point and off at
the console. Press and hold Wash Temperature Setting Up then
press Power. EcoSmart
LEDs will change.
· Press Spin Speed Up, the Spin Hold LED should be on for the
7.5 / 8.0kg (650mm wide).
· Press Power to confirm the setting and also exit this mode.
â
will give 4 short beeps and the pattern of
31