Mcp750 Module Installation - Motorola MCP750 Installation And Use Manual

Hardware Preparation and Installation
1

MCP750 Module Installation

!
Caution
1-22
4. Remove the PCI filler from the front panel.
5. Slide the edge connector of the PMC module into the front panel
opening from behind and place the PMC module on top of the base
board. The four connectors on the underside of the PMC module
should then connect smoothly with the corresponding connectors
(J11/12/13/14) on the MCP750.
6. Insert the four short phillips-head screws (provided with the PMC)
through the holes on the bottom side of the MCP750 and the PMC
front bezel and into rear standoffs. Tighten the screws.
7. Reinstall the MCP750 assembly in its proper card slot. Be sure the
module is well seated in the backplane connectors. Do not damage
or bend connector pins.
8. Replace the chassis or system cover(s), reconnect the system to the
AC or DC power source, and turn the equipment power on.
With mezzanine board(s) installed and headers properly configured,
proceed as follows to install the MCP750 in the CompactPCI chassis:
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground throughout the procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
Remove chassis or system cover(s) as necessary for access to the
CompactPCI modules.
Inserting or removing modules with power applied may result in damage
to module components.
Computer Group Literature Center Web Site