Motorola MCP750 Installation And Use Manual page 40

Compactpci single board computer
Table of Contents

Advertisement

To prevent injury, use extreme caution when handling, testing, and
!
adjusting this equipment. Dangerous voltages capable of causing death
exist.
Warning
3. Remove the filler panel from card slot 1 (system slot).
Avoid touching areas of integrated circuitry; static discharge can damage
!
these circuits
Caution
Note
4. Set the VIO on the backplane to either 3.3V or 5V, depending upon
5. Slide the MCP750 into the system slot. Grasping the top and bottom
6. Replace the chassis or system cover(s), making sure that no cables
http://www.motorola.com/computer/literature
The MCP750 must be installed in the CompactPCI system slot in
order to provide clocks and arbitration to the other slots. The
system slot is identified with a triangle symbol, which is marked
on the backplane. Some CompactPCI subracks may have a red
guide rail to mark the system slot.
your system's signaling requirements, and ensure the backplane
does not bus J3, J4, or J5 signals.
injector handles, be sure the module is well seated in the P1 through
P5 connectors on the backplane. Do not damage or bend connector
pins. Secure the MCP750 in the chassis with the screws provided,
making good contact with the transverse mounting rails to minimize
RF emissions.
are pinched. Cable the peripherals to the panel connectors,
reconnect the system to the AC or DC power source, and turn the
equipment power on.
MCP750 Module Installation
1
1-23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents