Coolant Level; Air Filter - Arctic Cat M 9000 King Cat Operator's Manual

Coolant Level

CAUTION
After operating the snowmobile for
the initial 5-10 minutes, stop the
engine, allow the engine to cool
down, and check the coolant level.
Add coolant as necessary.
Locate the filler neck located above the
driven clutch; then remove the coolant cap
from the filler neck. Verify that the coolant
is at the bottom of the tab in the filler neck.

NOTE: Under normal conditions
checking only the overflow tank
(located above the driven clutch) is
acceptable. Only if this tank does not
have coolant should the operator
have to remove the hood and check
the level at the filler neck.
Locate the coolant tank above the drive
clutch; then remove the plug from the
coolant tank. Add coolant to the full level
on the tank. Install the plug.
22
If the coolant is below the neck and if
coolant has been added, immediately
inspect for leakage and/or damage. If
leakage or damage is detected, take
the snowmobile to an authorized Arc-
tic Cat Snowmobile dealer for ser-
vice. If not under warranty, this
service is at the discretion and
expense of the snowmobile owner.
3. Remove the plug in the vapor tank
located above the exhaust. Once the
plug is removed, verify the coolant
is just below the treads. Install the
plug.
0747-547

Air Filter

The air filter inside the air filter housing
must be clean to provide good engine
power and gas mileage.
If operating the snowmobile in deep pow-
der conditions, the air filter should be
inspected for snow buildup.
1. Remove the left-side access panel;
then remove the clips securing the air
filter housing cover.
XM452A
2. Loosen the two knobs securing the air
filter to the inside of the housing; then
remove the filter.
CAUTION
YM-167B
XM470A