Lighting Instructions; To Turn On The Heater; To Turn Off The Heater - Fire Sense PH08-SA Instruction Manual & Parts List

LIGHTING INSTRUCTIONS

TO TURN ON THE HEATER.

1. Turn the control knob "OFF".
2. Slowly open the gas cylinder valve.
3. Press and turn the control knob to
" " position and hold for 30 seconds.
While holding down the control knob, press the igniter several
times until the pilot flame ignites. Release the knob after ignition.
Note: If the pilot flame does not light or it goes out, repeat Step 3.
To regulate the heat, turn the control knob to "LO" position or "HI"
position.
4. If the burner flame goes out accidentally or it is blown by wind,
turn off the heater and wait at least 5 minutes or more to let the
gas dissipate before relighting to avoid gas explosion. Repeat
steps 2 to 4.
NOTE:
· If a new tank has just been connected, please
allow at least one minute or more for the air in
the gas pipeline to purge out through the pilot hole.
· When lighting the pilot flame make sure that the
control knob is continuously depressed while
pressing the igniter button. Variable control knob
can be released after the pilot flame has been lit
for 20~30 seconds.
· Pilot flame can be watched and checked from the
peephole located on the base of burner.

TO TURN OFF THE HEATER.

1. Press and turn the control knob to
"OFF" position.
2. Turn off the valve on the gas cylinder and
disconnect the cylinder.
WARNING
Heater will be hot after use. Handle with extreme care.
-
FOR YOUR SAFETY
If at any time you are
unable to light burner
and smell gas, wait 5
minutes to allow gas to
dissipate before
attempting to light
heater. If after 1 minute
you are unable to light
burner, wait 5 minutes
and allow flammable
vapors to dissipate
before attempting to
light heater again.
17 -
OPERATION
WARNING