Cleaning And Maintenance - Fire Sense PH08-SA Instruction Manual & Parts List

CLEANING AND MAINTENANCE

To enjoy years of outstanding performance from your
heater, make sure you perform the following maintenance
on a regular basis:
Keep exterior surfaces clean.
1. Use warm soapy water for cleaning. Never use flammable or corrosive cleaning agents.
2. While washing your heater, be sure to keep the area around the burner and pilot assembly dry
at all times. If the gas control is exposed to water in any way, DO NOT try to use it. It must
be replaced.
Keep the heater area free and clean from combustible materials, gasoline or other flammable
vapors and liquids. Visually check burner flames.
Visually check the hose assembly inside the post and check for any cracks or worn sections.
1. Unscrew gas hose and regulator hose with 3/4'' inch open end wrench and adjustable
wrench.
2. Check if there are any cracks or worn sections on hose. If yes, contact your gas supplier
to replace the hose.
3. At least once a year, the unit should be inspected for the presence of spiders, spider
webs or other insects.
Air flow must be unobstructed. Keep controls, burner and circulating air passageways clean. Signs
of possible blockage include:
1. Gas odor with extreme yellow tipping of flame.
2. Heater does not reach the desired temperature.
3. Heater glow is excessively uneven.
4. Heater makes uneven popping noise.
Spiders and insects can nest in burner or orifices. This dangerous condition can damage heater
and render it unsafe for use. Clean burner holes by using a heavy-duty pipe cleaner. Compressed
air may help clear away smaller particles.
Carbon deposits may create a fire hazard. Clean dome and engine with warm soapy water if any
carbon deposits develop.
NOTE:
n a salt-air environment (such as near an ocean), corrosion occurs more
I
quickly than normal. If the heater is exposed to this type of environment, you
should frequently check for corroded areas and repair them promptly.
-
MAINTENANCE
WARNING
FOR YOUR SAFETY
DO NOT touch or move
heater for at least 45
minutes after use.
Allow all burner elements
to cool before touching.
19 -