Operating Instructions - Fire Sense 63057 Assembly / Care & Use Instructions

OPERATING INSTRUCTIONS

A minimum supply pressure of .5 psi is required for the purpose of input
adjustment of propane gas. Storage of an appliance indoors is permissible
only if the cylinder is disconnected and removed from the appliance. A cylinder
must be stored outdoors in a well-ventilated area out of the reach of children.
A disconnected cylinder must have dust caps tightly installed and must not
be stored in a building, garage, or any other enclosed area. The minimum
permissible gas supply pressure of 11 W.C. is required for purpose of hose
adjustment. The minimum hourly of 17,500 BTU is required input rating for
a heater for automatic operation rating less than full input rating.
The pressure regulator and hose assembly supplied with the appliance must
be used.
The installation must conform with local codes, or in the absence of local codes,
with national fuel gas code, ANSI Z223.1/NFPA54, natural gas and propane
Installation Code, CSA B149.1, or propane storage and handling code, B149.2
A dented rusted or damaged propane cylinder may be hazardous and should
be checked by your local cylinder supplier. Never use a propane cylinder with
a damaged valve connection. The propane cylinder must be constructed and
marked in accordance with the specifications for LP gas cylinders of the U.S.
Department of Transportation (DOT) or the standard for cylinders, spheres and
tubes for transportation of dangerous goods and commission, CAN/CSA-B339.
• The cylinder must have a listed overfilling prevention device.
• The cylinder must have a connection device compatible with the connection
for the appliance.
• The cylinder used must include a collar to protect the cylinder valve.
• Never connect an unregulated propane cylinder to the heater.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
Hose / Regulator Regulator / Cylinder
Connection Connection
• Do not store a spare LP-gas
cylinder under or near this
appliance.
• Never fill the cylinder
beyond 80 percent full.
• Place the dust cap on
the cylinder valve outlet
whenever the cylinder is not
in use. Only install the type
of dust cap on the cylinder
valve that is provided with
the cylinder valve. Other
types of caps or plugs may
result in leakage of propane.
8