Lighting Instructions - Fire Sense 1337 Instructions And Parts Manual

Before Lighting:
Heater should be thoroughly inspected before each use. Have a qualified service
person inspect the heater at least annually. If relighting a hot heater, always wait
at least 5 minutes. This heater has been tested for quality assurance

LIGHTING INSTRUCTIONS

TO TURN ON THE HEATER.
1. Turn the control knob "OFF".
2. Slowly open the gas cylinder valve fully.
3. Press and turn the control knob to
"HI" position ( counter-clockwise 90°).
4. Check for flame at the burner. If burner
does not light immediately, turn control
knob to "OFF" position and repeat from
Step 2. Allow 30 seconds between ignition
attempts for gas to dissipate. Several
attempts may be necessary.
5. Once the burner is lit, keep control knob depressed for 15 seconds.
6. For lowest heat, push in and turn the control knob to "LOW." For highest
heat, push in and turn the control knob to "HI."
Note: If the pilot flame does not light or it goes out, repeat Step 3
above.
NOTE:
· If a new tank has just been connected, please allow
at least one minute or more for the air in the gas
pipeline to purge out through the pilot hole.
· When lighting the pilot flame make sure that the
Variable control knob is continuously depressed while
pressing the igniter button. Variable control knob can
be released after the pilot flame has been lit
for 20~30 seconds.
· Pilot flame can be watched and checked from the
peephole located on the base of burner.
·If the pilot flame does not light or it goes out, repeat
Step 3. If the burner flame goes out accidentally or it is
blown out by wind, turn off the heater and wait at least 5
minutes or more to let the gas dissipate before relighting to avoid possible gas
explosion. Repeat steps 2 to 4.
·WARNING: Failure to follow this lighting procedure may result in flame
roll out beyond the emitter grid.
-
OPERATION
12 -
WARNING
FOR YOUR SAFETY
If at any time you are
unable to light burner
and smell gas, wait 5
minutes to allow gas to
dissipate before
attempting to light
heater. If after 1
minute , you are
unable to light the
burner, wait 5 minutes
and allow flammable
vapors to dissipate
before attempting to
light heater again.