Lighting Instructions - Fire Sense PH01-S Instruction Manual & Parts List

LIGHTING INSTRUCTIONS

TO TURN ON THE HEATER:
1. Turn the control knob "OFF".
2. Open gas valve fully.
3. Press and turn the control knob to
"HI" position (counterclockwise 90° ).
Press down the control knob and hold
3-5 seconds. While holding down the control knob,
press the igniter button several
times until the pilot flame ignites.
Hold the knob about 30 seconds and then release.
Note: If the pilot flame does not light or it goes out,
repeat Step 3 above.
NOTE:
·
If a new tank has just been connected, please
allow at least one minute or more for the air in
the gas pipeline to purge out through the pilot
hole, or simply do Step 3.
· When lighting the pilot flame make sure that the
variable control knob is continuously depressed
while pressing the igniter button. Variable
control knob can be released after the pilot
flame has been lit for 20~30 seconds.
· Pilot flame can be watched and checked from the
peephole located on the base of burner.
·If the pilot flame does not light or it goes out,
repeat Step 3.
If the burner flame goes out accidentally or it is
blown out by wind, turn off the heater and wait
at least 5 minutes or more to let the gas
dissipate before relighting to avoid possible gas explosion.
Repeat steps 2 to 4.
TO TURN OFF THE HEATER.
1. Press and turn the control knob to "OFF" position.
2. Turn off the valve on the gas cylinder and
disconnect the cylinder.
WARNING
FOR YOUR SAFETY
If at any time you are
unable to light burner and
smell gas, wait 5 minutes
to allow gas to dissipate
before attempting to light
heater. If after 1 minute,
you are unable to light
burner, wait 5 minutes
and
vapors to dissipate before
attempting to light heater
again.
- 14 -
OPERATION
allow flammable